AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Silhouette 7.5.8 / 2023.0.3 for ipod instal12/11/2023 Unzip the folder by right-clicking and selecting 'extract all'.IMPORTANT: These steps must be completed on a PC computer that is either a) not running Windows 10 ( or above) or b) an alternate computer that allows a successful connection. To update your Portrait 1 firmware and resolve the connection issue: Unfortunately, there are no other workaround options for this issue. NOTE: If this process is not successful in resolving the connection issues with your machine, or if you are unable to continue with any of the steps listed above, please retry the steps from the beginning. Connect the Cameo 1 to the computer via USB cable.Please wait a few minutes until the LCD displays, "Write Finish." The update sequence will start automatically.Once 'Boot Ver1.00' is displayed on the LCD, release the buttons.While holding down these buttons, plug the power cord into the Cameo 1 machine.Press and hold down the left and right arrow keys at the same time.Place the SD card into the Cameo 1 machine's SD reader slot.Power off and disconnect all cords and cables from the Cameo 1 machine.There cannot be any other files or folders on the SD card. IMPORTANT: The SD card must be blank prior to saving this file onto the card. NOTE: The 'cc300.mhx' file may be in an unzipped 'cc300' folder that was created when you extracted the previous folder Save the extracted 'cc300.mhx' file onto a blank SD card.Select a destination on your computer where you want to extract the files.Unzip the 'cc300' folder by right-clicking and selecting 'extract all'.Click here to download and save the firmware file.If you do not have these, you will need to obtain them in order to proceed with this firmware update process below. A basic SD card with 2GB capacity or less, is required. IMPORTANT: These steps require a blank SD card and a compatible SD card reader for your computer. To update your Cameo 1 firmware and resolve the connection issue: While Silhouette is no longer able to officially support the connectivity of these older models with newer Windows operating systems, workaround options may be available below. All models older than those listed above.Modified on: Sun, 20 Nov, 2022 at 10:17 AMĭue to Microsoft updates, some older Silhouette cutting machine models may be unable to connect successfully via USB. Solution home Software & Apps Connectivity Silhouette Studio Can't Connect to Machine - Windows 10 (or higher) with Older Model
0 Comments
Read More
Leave a Reply. |